You can repeat this process to confirm communication with all of your connected instruments. No other special device files are needed. The “shared” version allows the GPIB interface to be shared among more than one instance of spec running on the same platform. To communicate with your instrument at Address 4, follow these instructions:. Next, you can go the directory with the extracted linux-gpib sources and execute the commands:.

Uploader: Gole
Date Added: 11 October 2011
File Size: 66.12 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 33963
Price: Free* [*Free Regsitration Required]

These productivity tools help you focus on developing your tpib-enet applications instead of trying to track down obscure problems or establishing communications with your instruments. This site uses cookies to offer you a better browsing experience.

The NI driver distribution contains instructions for installation, which should be followed. Install Instrument Drivers Next. View the properties for the device.

Instruments must be powered on and connected to the GPIB controller to be recognized.

Choose Extra library flags no? Note, though, that utility displays hexadecimal numbers while spec ‘s configuration uses decimal. If you want to use VISA you will need to purchase the released version of the driver. Turn on the front-panel power switch.

Installing GPIB-ENET/100 Controllers

Once you have completed these steps, you need a fast way to progress from interactive mode to programming mode so you can immediately begin writing your tests without a tedious transition process. I need some help regarding this. The current hostname is displayed. Configuration in Windows for USB.


Instrument Control (GPIB, Serial, VISA, IVI)

Hostname is a required field. Finally, to link the linux-gpib library with specgo to the spec distribution directory. The spec linking won’t work with a -lgpib type of argument due to the idiosyncrasies of the spec linking.

Again, the NI 2. Connect the other end to gpib-fnet GPIB instrument. If you have two or more instruments on the bus, you can disconnect all instruments except one to determine its address.

Talking SCPI with a gpib-enet controller – Raspberry Pi Forums

Once you have determined the GPIB address of your instruments, it is easy to establish communications to verify that you can send and receive data to and from the instrument. The most recent driver package circa August is available from the download pages at the NI website at ni.

Message 3 of 4. If spec has already been installed, remove the file spec in the spec distribution directory before running the installation script to insure that the spec executable gets relinked.

One of the following should occur:. The “shared” version allows the GPIB gipb-enet to be shared among more than one instance of spec running on the same platform. Connect the other end of the Ethernet cable to your Ethernet network. Once your computer restarts to complete the installation of the Gpib-eet Resource Quick Links spec latest update notes spec manual spec help pages spec guides spec hardware.


Using GPIB ENET/ under Linux – Discussion Forums – National Instruments

Consult your network administrator if you do not know whether your network uses DHCP. Refresh the list of devices, after the device reboots, to verify that the hostname is now valid. This is indicated by an exclamation point! Many times, systems are powered down and cables are disconnected from instruments for maintenance or system configuration changes.

The built-in support means no kernel-level driver is used, so there is no dependency on Linux kernel version. Gib-enet with release 0. With this test panel, you can set properties for your instrument communication as well as read and write to the instrument.

If your subnet mask is